Hi... got my cube set up and tried to connect to wifi, but not having much luck.
Via the iOS app, I always get an error telling me it couldn't configure the wifi credentials for my particle device, and to reset and try again.
Via USB, I've had what looks like success using the command line. I hold setup until I get a slow blinking dark blue. From Terminal (I'm on a Macbook) I've run 'particle serial wifi'... It says my device will restart, and when it does, I get an odd cycle...
The status light flash slowly green once or twice, then slowly cyan, then rapidly cyan, VERY rapidly cyan, then sometimes a short burst of very rapid orange (I think, could be red), and the cycle starts again. Haven't read anything thus far in the forums that sounds like that (which is difficult to describe, I know.... perhaps I can post a video to youtube.)
I've tried every variation of resetting the cube. Ran Cube Doc (which I had problems getting working as well, but ultimately ran successfully). Might try safe mode next, but not sure that's going to make a difference.
Oh, I'm also on the latest airport extreme. I've turned off my 5Ghz network because I saw two of my network's name in the list of possible networks, figured it might be getting confused. No dice.